Page 21

EDNE DEC 2014

designideas Monitor 15 contacts with one PIC input Benabadji Noureddine  Several previously published Design Ideas and appnotes show how to use many pushbuttons with a minimum number of inputs. They require an RC circuit where the timing can be measured to identify which pushbutton has been pressed, or an ADC input, with resistors forming a divider for each pushbutton pressed. The following Design Idea shows another simple way to use up to 15 pushbuttons with only one I/O. The microcontroller chosen must contain an internal comparator with selectable values for the internal voltage reference VREF. The majority of 8-bit PIC microcontrollers in the mid-range family feature one or two internal comparators with just this. As a simple and practical example, the circuit in Figure 1 uses an 8-bit PIC controlling a 4-bit LED display to show which button has been pressed. A comparator interrupt routine reacts immediately to any pushbutton pressed. The routine cycles through VREF values until the comparator output COUT returns high, which will indicate the pushbutton pressed. The fully commented assembler source code takes less than 100 words. It is not overly optimised, so as to simplify understanding and make translation to other controllers easy. References: 1 Bernhard Linke: Sense multiple pushbuttons using only two wires 2 Petre Petrov: Measure two resistive sensors or multiple switches with a single Schmitt 3 AN234: Hardware techniques for PICmicro microcontrollers (MICROCHIP | 2003) 4 Tips’n tricks for 8-pin PICmicro microcontrollers (MICROCHIP | 2003 Figure 1. Sense 15 buttons with one input www.edn-europe.com EDN Europe | DECEMBER 2014 21


EDNE DEC 2014
To see the actual publication please follow the link above