Page 11

EETE SEPT 2013

eu.mouser.com Primary Logo The Newest Products for Your Newest Designs® The widest selection of the newest products. Over 4 Million products from over 500 manufacturers Authorised distributor of semiconductors and electronic components for design engineers. memories,” he said But the path for the introduction of innovative non-volatile memory is notoriously difficult. There are many similar ReRAM, conductive bridging and other technologies that are being researched but struggling to compete with the incumbent flash memory technology. Phase-change memory was thought to offer similar scaling benefits beyond NAND flash but the R&D phase took more than 40 years, and although it is now in the commercial marketplace and has some reported deployments, it is only made at feature sizes that are larger than mainstream flash memory. Ron Neale, a memory device expert who has contributed review articles on non-volatile memory to E Times, raised some areas of concern about the technology. One is the use of silver as an electrode material in the fab. Like copper, unless carefully controlled, silver can have a contaminating effect in a wafer fab. This might inhibit foundries from adopting the technology. In email correspondence with E Times, Neale said: Silver is a fast diffuser and in the past it has been shown to have had a detrimental effect on MOS gate oxides. However - although mostly as a BEOL process - a good experience base of the use of silver pastes as conductors in direct contact with silicon is building from the photovoltaic industry. A second area Neale raised is the blocking diode effect used for matrix isolation which, according to a 2011 PhD thesis out of University of Michigan, while apparently robust was not at that time fully understood. “There are at least a couple of candidate locations in the memory cell for the site of the non-linear matrix-isolating element,” Neale said in email. A third area is the thermal-dependence of the filament creation and maintenance, which Crossbar describes as being “minimal.” “So far Crossbar appears to have done most things in the right way and this could be the flash-replacement non-volatile memory that finally takes off,” Neale said. “All aspects of the claimed performance of their ReRAMs can be verified in large arrays - but that should also mean the publication of the full details of reliability testing.” he added. Since its founding in 2010, Crossbar has filed more than 100 patents related to the development and manufacturing of Re- RAM with 30 already issued. One of the biggest claims that may yet aid adoption is that the technology is completely CMOS compatible and can be integrated into the back-end-of-line of any standard CMOS wafer fab. www.electronics-eetimes.com Electronic Engineering Times Europe September 2013 11 Go Widest_UK_93x277_Phil.Lumi.indd 1 8/29/13 9:30 AM Fig.3: Comparisons for Crossbar memory against contemporary flash memory. Source: Crossbar Inc.


EETE SEPT 2013
To see the actual publication please follow the link above